Basic Structure And Working Principle Of Hydraulic System

The hydraulic system mainly includes refueling pump, hydraulic water tank, filter, pressure reducing valve, overflow valve, lifting cylinder, stretching cylinder, pliers liquid tank, hydraulic tank, hydraulic motor, various hydraulic operation valves, etc. Before the equipment leaves the factory, the pressure of the overflow valve, pressure reducing valve, and various pressure valves should be adjusted to ensure the safe operation of the hydraulic system. Users should not make hasty changes during use.

The hydraulic system includes the main hydraulic system and the steering hydraulic system that share a common hydraulic oil tank.

1. Main hydraulic system

The main hydraulic system provides hydraulic power during equipment adjustment and drilling operations, consisting of various valves to control the operation of various hydraulic equipment and ensure safe operation.

2. Steering hydraulic system.

The steering hydraulic system provides hydraulic power for the hydraulic power steering of the front axle of the vehicle. It is composed of various valves to regulate the hydraulic system pressure, flow rate, and large flow rate, ensuring that the vehicle rotates lightly, flexibly, and safely.

structure characteristics

The main hydraulic system consists of the following components:

1) Hydraulic water tank: storage, cooling, sedimentation, and filtration of hydraulic oil. The installation of the fuel tank is as follows:

Manual cover plate, installed on the top of the oil tank, with two installed, including a hydraulic air filter installed on the access hole cover in the return area of the oil tank.

Hydraulic air filter, oil tank circulating air filter, and oil filter during oil tank refueling.

Water supply system, 2 installed at the front of the fuel tank, 2 high and low water supply systems, high water supply system, displaying the fuel level after landing. The low-level meter displays the oil surface after being erected.

An oil temperature gauge is installed at the front end of the oil tank to measure the oil temperature. The normal operating oil temperature is 30-70. There are two main return ports, which are installed on the bottom plate of the oil tank and are equipped with one-way valves. The main return pipeline and overflow valve return ports are connected with one-way valves, which automatically close when repairing hydraulic pipelines to prevent oil loss in the oil tank.

2) Hydraulic oil pump: single gear structure, two sets, each installed on two hydraulic transmissions, driven by the hydraulic torque converter pump wheel, the engine rotates, and the pump can be driven with a power box. The power oil extraction tank is composed of a hydraulic clutch. When hydraulic action is required, the "hydraulic pump clutch" handle of the driller's control box can be operated to achieve the "oil pump I close" position, oil pump I close, and output working pressure oil; The handle is located in the "oil pump II closed" position, and the oil pump II is closed to output working pressure oil. The handle is in the center, and both oil pumps have disengaged and stopped rotating.

3) Relief valve: Pilot operated structure, two sets, each installed on the air outlet port of the main hydraulic pump. Adjust system pressure to prevent system overload and protect system and component safety.