Analyzing how to adjust the hydraulic cylinder throttle

Aug 06, 2023

After using bulldozers, loaders, excavators, and truck cranes for a period of time, there are often scenes of reduced sensitivity of control mechanisms and delayed action of task mechanisms.

1. Scenery

The exhaust, operation, and sound of the starter are all abnormal, making it difficult to start and slow down; The hydraulic system oil is purified, and the internal and internal oil leakage of hydraulic components, pipelines, and joints is significant. The hydraulic cylinder cannot be locked and actively retracts; The transmission chains of the control handles of the entire machine are loose, causing blockages and difficulty during control.

2. Cause

The important thing is long-term overload tasks and working in environments that do not meet the requirements; Inadequate daily maintenance and failure to meet standard requirements for major, medium, and minor repairs.

3. Method

(1) Strictly manage and continuously improve the skills and qualities of operators to ensure accurate use of hydraulic cylinders in construction machinery.

(2) Enhance the daily maintenance and review of equipment, and improve the completeness of equipment.

(3) Improve the skills, water temperature, and sense of obligation of trainees to ensure the quality of major, medium, and minor repairs. Appropriately added training equipment, tools, instruments, and skill materials.

(4) Adjust and repair the machinery.

4. Adjustment and repair methods

(1) Adjusting the throttle of the initiator

For example, a diesel engine installed on a truck crane may experience slow growth and inability to achieve speed and power when the hydraulic cylinder holds its throttle on the vehicle after temporary use. At this point, it is necessary to review and adjust all transmission chains of the pedal accelerator on the vehicle. This task requires two people, one to hold the accelerator pedal while getting on the car, and the other to observe the static state of the speed control lever at the fuel injection pump. Although the operator in the driver's cab of a crane that has been in use for many years has already pressed the accelerator pedal to the limit position, in practice, the speed control lever of the diesel engine fuel injection pump sometimes cannot reach the limit position. Due to the position of the speed control lever in the entire machine, which is not easily observed by operators, its idle stroke is often ignored. Therefore, it is necessary to inspect it for a while and try Tianjin stainless steel mesh several times. The reason for this situation is that the size chain of the transmission system of the diesel engine throttle has changed, resulting in excessive accumulation of idle travel at both ends; The second reason is that some fasteners on the transmission installation, such as set screws, become loose. At this point, it should be gradually reviewed according to the size chain of the throttle transmission. When the accelerator pedal is fully pressed, the speed control lever must also reach the limit. The idle stroke on the throttle transmission chain should be reserved for hydraulic cylinders as requested, and should be tightened and adjusted based on the detailed condition of each equipment.

(2) Repair of gear pump

The wear of gear pumps is mainly due to the wear of the inner and outer surfaces, tooth tips, and tooth thickness of the pump casing. The repair method is to brush and plating a layer of metal coating on the worn surface of the pump casing, to restore its original size; For gears, electroplating can be applied to the top and thickness of the teeth to restore the size of the tooth thickness and top; Individual shaft sleeves are only replaced without repair, and when replacing with new shaft sleeves, it is necessary to pay attention to their axial length and not leave any space. It is possible to accurately measure several gear pumps of the same model that have been used, and then select gears and pump bodies with relatively light wear for reassembly and assembly, and conduct experiments on an experimental bench.